# Ruled Line Deviation Adjustment (Auto)

#Required Tools

• Cut sheet paper feeding: PGPP250: Premium Glossy Photo Paper (250) that is 16 inches
• Roll paper feeding
  
  • 44 inch machine: PGPP250: Premium Glossy Photo Paper (250) that is 44 inches
  • 36 inch machine: PGPP250: Premium Glossy Photo Paper (250) that is 36 inches
  • 24 inch machine: PGPP250: Premium Glossy Photo Paper (250) that is 24 inches

#Estimate Time

• Uni-D: Approx. 5 min.
• Bi-D: Approx. 5 min.

#Startup Mode

Repair mode

#Standard Values

---

#Step

<When using Cut Sheet Paper (PGPP250 16 inches)>

1. Start the printer in repair mode. Turn the power on while touching [Screen Center], and keep pressing until the mode select screen is displayed. Touch the center of the panel to start repair mode.
   

2. Set the paper.

3. Start the Service Program, and select Cutter Motor Measurement & Auto Adjustment.Select Ruled Line Deviation Adjustment.
   

4. Select the [Automatic adjustment (Uni-D)] tab, click [Confirm], and confirm the current configuration type.

5. Using the radio buttons, select the current configuration type.

6. Select [Cut Sheets] with the radio buttons, and click [Create Media].

7. Eject the role paper.

8. Raise the paper support to the cut sheet paper feed position, and then set the created media to 44 inches wide and 16 inches long from Cut Sheet [User-Defined], and feed the paper. Feed the paper again.
   
9. Set the cut sheet along the edge guide (A) on the paper support home side.
   
10. Click the [Automatic Adjustment] button. The adjustment pattern is printed.
    
11. The adjustment pattern is read.

12. In the same manner, Select [Auto Adjustment (Bi-D)], perform the Auto Adjustment (Bi-D).

    Check Point / チェックポイント

    If the adjustment fails or the pattern is misaligned even after the adjustment, the adjustment is repeated until the pattern matches.

<When using each size Roll Paper>

1. Start the printer in repair mode. Turn the power on while touching [Screen Center], and keep pressing until the mode select screen is displayed. Touch the center of the panel to start repair mode.
   

2. Set the PGPP250 according to the size of the machine and feed it.

3. Start the Service Program, and select Cutter Motor Measurement & Auto Adjustment.Select Ruled Line Deviation Adjustment.
   

4. Select the [Automatic adjustment (Uni-D)] tab, click [Confirm], and confirm the current configuration type.

5. Using the radio buttons, select the current configuration type.

6. Using the radio buttons, select [Roll Paper].

7. Click the [Automatic Adjustment] button. The adjustment pattern is printed.
   
8. The adjustment pattern is read.

9. In the same manner, Select [Auto Adjustment (Bi-D)], perform the Auto Adjustment (Bi-D).

   Check Point / チェックポイント

   If the adjustment fails or the pattern is misaligned even after the adjustment, the adjustment is repeated until the pattern matches.