CR Slider (Full)

Adjustment / 調整

When replacing/removing this part, refer to the following pages and make sure to perform the required operations before assembly/reassembly.

  1. Remove the single screw and remove the cover (A).
    • : Silver M3x10 Cup P-tite screw
  2. Insert a screwdriver and rotate the CR Manual Unlock Gear (A) counter-clockwise.

    CR locked state

    CR unlocked state
  3. Move the CR Unit (A) to the Full side.
  4. Insert a flathead screwdriver and release the two hooks, and remove the screw cover (A).
  5. Open the Printer Cover (A) and the Cutter Cover (B).
  6. Remove the three screws at the front side.
    • : Silver M3x10 Cup P-tite screw
    • : Silver M3x8 Cup S-tite screw
  7. Remove the screw at the top side.
    • : Silver M3x8 Cup S-tite screw
  8. Remove the four screws at the rear side.
    • : Silver M3x8 Cup S-tite screw with plastic washer
    • : Silver M3x8 Cup S-tite screw
  9. Remove the four screws at the left side.
    • : Silver M3x8 Cup S-tite screw

  10. On the printer rear side, release the dowel of the Full Side Cover Unit (A).

  11. Remove the Full Side Cover Unit (A) from the dowels, and remove it while it in the direction of the arrow.

    Assemble / 組み立て

    When installing the Full Side Cover Unit (B), carefully the Head FFC (A) so that it does not damage.
  12. Remove the screw, and remove the CR Slider (Full) in the direction of the arrow.
    • : Silver M3x10 Cup P-tite screw
    Caution / 注意

    The new CR Slider (A) may have 2 sheet sections (B) floating. In this case, press the 2 sheet sections (B) flat. After this, lubricate and install.
    Lubrication / 注油

    Refer to the following to perform lubrication.

Adjustment / 調整

When replacing/removing this part, refer to the following pages and make sure to perform the specified operations including required adjustment.

Lubrication / 注油

Before attaching the part, refer to the following and then lubricate.