CIS Module Center

  1. Push two buttons (A), and open the Scanner Unit (B). (Only perform for SC-P8500DM series/SC-T7700DM series/SC-T5700DM series)
  2. Remove the screw on the printer home side. (Only perform for SC-P8500DM series/SC-T7700DM series/SC-T5700DM series)
  3. Remove the C Shape Washer (A). (Only perform for SC-P8500DM series/SC-T7700DM series/SC-T5700DM series)

    • : Black M3x4 Cup Step type S-tite screw
  4. Remove the Fixing Slider (A) from shaft. (Only perform for SC-P8500DM series/SC-T7700DM series/SC-T5700DM series)
  5. Remove the screw on the printer full side. (Only perform for SC-P8500DM series/SC-T7700DM series/SC-T5700DM series)
  6. Remove the C Shape Washer (A). (Only perform for SC-P8500DM series/SC-T7700DM series/SC-T5700DM series)

    • : Black M3x4 Cup Step type S-tite screw
  7. Remove the Fixing Slider (A) from shaft. (Only perform for SC-P8500DM series/SC-T7700DM series/SC-T5700DM series)
  8. Open the Scanner Unit (A). (Only perform for SC-P8500DM series/SC-T7700DM series/SC-T5700DM series)
  9. Remove the C Shape Washer (A) and the Fixing Slider (B). (Only perform for SC-P8500DM series/SC-T7700DM series/SC-T5700DM series)
  10. Remove the Washer (A) and the Strap (B). (Only perform for SC-P8500DM series/SC-T7700DM series/SC-T5700DM series)
  11. Remove the two screws and remove the Left Front Guide B (A).

    • : Silver M3x6 Bind S-tite screw
  12. Remove the two screws and remove the Right Front Guide B (A).

    • : Silver M3x6 Bind S-tite screw
  13. Remove the two screws, lift up the CIS Module Center (A), and turn over.

    • : Black M3x4.9 screw with rubber
    • : Silver M3x8 Cup S-tite screw

  14. Lift the connector lock (A), remove the CIS Module Center FFC (B) from the CIS Module Center connector, and remove the CIS Module Center (C).

    Assembly / 組み立て
    • Be careful not to touch the CIS Module glass.
    • When connecting the CIS Module Center FFC, secure firmly using the connector lock.
    • Screw A (A) which secures the CIS Module Center is tightened together with the spacer (B) and the washer (C). When securing screw A (A), fit the spacer (B) and the washer (C) in the order as shown in the diagram below.

Adjustment / 調整

When removing/replacing this part, refer to following page and make sure to perform the specified operations including required adjustment.