# Rear AD Adjustment (BPE)

#Required Tools

Standard sheet (JETRAS)

#Estimate Time

Approx. 1 min.

#Startup Mode

Inspection mode

#Standard Values

---

#Step

1. Start the printer in inspection mode. Turn the power on while touching [Screen Left], and keep pressing until the mode select screen is displayed.
   
2. Select Inspection Menu. Check that “Inspection Menu” is shown in red, then touch the center of the touch panel.
   
3. Touch the right on the panel to select [Rear AD (BPE)], and touch the center of the panel.

   
   

   Check Point / チェックポイント

   Perform rear AD adjustment of the UPE Sensor before performing rear AD adjustment of the BPE Sensor.

4. Check that “Rear AD (BPE) OK?” is displayed, and touch the center of the panel.

5. When a value is displayed, touch the center of the panel.

6. When “OK” is displayed, touch the center of the panel to finish the adjustment. If “Retry Rear AD Adjust” is displayed, perform the adjustment again. If “Retry Rear AD Adjust” is still displayed, the BPE Sensor is faulty. Replace it and then perform the adjustment again.