Borderless Printing Specifications

Supported Pape

Refer to following section.

Roll Paper Cutting
Printer driver settingsCutting OperationExplanation
Normal Cut

The default printer driver setting is Normal Cut.
Single Cut

  • The top area may become slightly uneven depending on the image since the print operation stops while cutting the top edge of the roll paper.
  • If the cut position shifts out of place, very small bits of images on continuous pages sometimes are left at the top and bottom margins. If this happens, adjust the cut position.
  • When only printing one sheet, or when printing multiple sheets, perform the same operation as Double Cut. When continuously printing multiple sheets, the printer cuts 1 mm inside on the top edge of the first page and the bottom edge of the subsequent pages to avoid showing margins.
Double Cut

  • The top area may become slightly uneven depending on the image since the print operation stops while cutting the top edge of the roll paper.
  • The printed paper is approximately 2 mm shorter than the specified size since the printer cuts the paper inside the image to avoid showing top and bottom margins.
  • After cutting the bottom edge of the previous page, the printer feeds the paper, and then cuts the top edge of the following page. Although this produces 60 to 127 mm cut-off pieces, the cut is more accurate.
  • If there is a margin at the top, perform Adjust Cut Position.