1st Roll Spindle Lock Position Detection Sensor Home

  1. Remove the two screws and remove the Home Side 1st Roll Paper Guide (A).

    • : Silver M3x8 Cup S-tite screw

    Assemble / 組み立て

    There are two positioning locations.
  2. Remove the single screw and then remove the 1st Roll Spindle Lock Position Detection Sensor Home cover (A).
    • : Silver M3x8 Cup S-tite screw
  3. Remove the cable (A) from the connector.
  4. Release the hook of back side and then remove the 1st Roll Spindle Lock Position Detection Sensor Home (A).

Adjustment / 調整

When removing/replacing this part, refer to following page and make sure to perform the specified operations including required adjustment.