# PF Encoder Sensor Harness

1. Insert a flathead screwdriver and release the two hooks, and remove the screw cover (A).
   
2. Open the Printer Cover (A) and the Cutter Cover (B).
   
3. Remove the three screws at the front side.
   
   • : Silver M3x10 Cup P-tite screw
   • : Silver M3x8 Cup S-tite screw
4. Remove the screw at the top side.
   
   • : Silver M3x8 Cup S-tite screw
5. Remove the four screws at the rear side.
   
   • : Silver M3x8 Cup S-tite screw with plastic washer
   • : Silver M3x8 Cup S-tite screw
     
6. Remove the four screws at the left side.
   
   • : Silver M3x8 Cup S-tite screw

7. On the printer rear side, release the dowel of the Full Side Cover Unit (A).
   

8. Remove the Full Side Cover Unit (A) from the dowels, and remove it while it in the direction of the arrow.
   

   Assemble / 組み立て

   When installing the Full Side Cover Unit (B), carefully the Head FFC (A) so that it does not damage.

9. Remove the spring (PF) (A).
10. Loosen the two screws to loosen the PF Belt (B).

11. Detach the PF Belt (B) from the pinion gear (C) of the PF Motor, and remove the PF Belt (B).
    

    • : Silver M4x8 Cup S-tite screw

    Assemble / 組み立て

    To strain the PF Belt properly, follow the procedure below to attach the belt. Attach the PF Belt. Attach the spring (PF). Tighten the two screws.

    Adjustment / 調整

    Refer to the following to perform adjustments. PF Belt

12. Remove the 2 screws, and then remove the PF Scale Encoder Unit (A).
    
    • : Silver M3x8 Cup S-tite screw
13. Remove the screw.
    
    • : Silver M2x6 P-tite screw
14. Disengage the hook and the two dowels on the back side, and detach the PF Scale Encoder (A).
    
15. Release the FFC (A) from the two tabs.
    
16. Remove the FFD (B) from the connector (A), and remove the PF Scale Encoder (C).
    
    

    Adjustment / 調整

    Refer to the following to perform adjustments. PF Encoder

17. Remove the seven screws and then remove the CH83 Main-B Board Cover (A).
    
    • : Silver M3x8 Cup S-tite screw

    Assemble / 組み立て

    Take care that the cables do not get pinched.

    
    

18. Disconnect the SUB PF Encoder Sensor Harness from the connector (CN72) on the CH83 Main-B Circuit Board.
19. Pull out the PF Encoder Sensor Harness through the hole in the frame.
20. Peel off the PF Encoder Sensor Harness.