Bind Screw3 x 12 (w/washer) (WF-M5899 Series)

  1. Remove the four screws and then remove the Rear Housing Assy (A).

    • : C.B.P-TITE-SCREW-3x10-F.ZN-3C
    Assembly / 組み立て

    Attach the two dowels of the Rear Housing Assy (A) to the positioning holes on the Housing Left (B) and the Housing Right (C).
  2. Disengage the hook, and remove the Maintenance Box Cover (A).
  3. Open the ADF/SCN Unit and remove the screw securing the Housing Right (A).

    • : C.B.P-TITE-SCREW-3x10-F.ZN-3C
  4. Remove the three screws securing the Housing Right (A).

    • : C.B.P-TITE-SCREW-3x10-F.ZN-3C
  5. Lift the Housing Right (A) upward to release the two hooks on the front side of the Housing Right (A).

  6. Remove the dowels to the rear, and lift up the Housing Right (A) to remove it.

    Assembly / 組み立て

    Insert the eight tabs on the Housing Right (A) to the positioning holes of the Housing Upper (B) and the RIPS Unit (C).
  7. Open the ADF/SCN Unit and remove the screw securing the Housing Left (A).
    • : C.B.P-TITE-SCREW-3x10-F.ZN-3C
  8. Remove the two screws securing the Housing Left (A).

    • : C.B.P-TITE-SCREW-3x10-F.ZN-3C

  9. Lift the Housing Left (A) upward to release the two hooks each on the front side and rear side of the Housing Left (A), and then remove the Housing Left (A).

    Assembly / 組み立て

    Insert the eight tabs on the Housing Left (A) to the positioning holes of the Housing Upper (B) and the RIPS Unit (C).
  10. Remove the six screws securing the Housing Upper (A).
    • : C.B.P-TITE-SCREW-3x10-F.ZN-3C
  11. Lift the Housing Upper (A) and remove the Housing Upper (A) toward you.
  12. Release the FFC (A) from the three hooks.

  13. Rotate the gear (B) of the Ink System Unit (A) in the direction of the arrow, and move the CR Unit (C) to the left side.

    Caution / 注意

    When rotating the gear of the Ink System Unit, take extra care not to damage or disconnect the FFC by touching it.
  14. Remove the two screws, and then remove the Head Upper Cover (A).

    • : C.B.P-TITE-SCREW-3x10-F.ZB-3C
  15. Remove the two screws, and remove the Ink Tube Joint Cover (A).

    • : C.B.P-TITE-SCREW-3x10-F.ZN-3C

  16. Remove the film (A) from the hook and remove the Ink Tube Joint Cover (B).

    Assembly / 組み立て

    Set the film (B) under the rib of the Ink Tube Joint Cover (A).

  17. Remove the two Bind Screw3 x 12 (w/washer).