# PDL Board (WF-M5899 Series)

1. Remove the four screws and then remove the Rear Housing Assy (A).
   
   
   • : C.B.P-TITE-SCREW-3x10-F.ZN-3C

   Assembly / 組み立て

   Attach the two dowels of the Rear Housing Assy (A) to the positioning holes on the Housing Left (B) and the Housing Right (C).

2. Open the ADF/SCN Unit and remove the screw securing the Housing Left (A).
   
   • : C.B.P-TITE-SCREW-3x10-F.ZN-3C
3. Remove the two screws securing the Housing Left (A).
   
   
   • : C.B.P-TITE-SCREW-3x10-F.ZN-3C

4. Lift the Housing Left (A) upward to release the two hooks each on the front side and rear side of the Housing Left (A), and then remove the Housing Left (A).
   

   Assembly / 組み立て

   Insert the eight tabs on the Housing Left (A) to the positioning holes of the Housing Upper (B) and the RIPS Unit (C).

5. Peel off the CRCM FFC (B) from the CRCM FFC Sheet (A).
   
   
6. Peel off the double-sided tape at two locations and then remove the CRCM FFC Sheet (A).
   
   
7. Disconnect the FFC (B) from the connector (CN102) of the PDL Board (A).
   
8. Remove the screw and remove the PDL Board Assy (A).
   
   • : C.B.S-TITE-SCREW-3x6-F.ZN-3C
9. Remove the two screws, then remove the PDL Board (B) from the Shield Plate (A).
   
   • : C.B.S-TITE-SCREW-3x6-F.ZN-3C